气体压强对纳秒激光诱导空气等离子体特性的影响

环境气体的压强对激光诱导等离子体特性有重要影响.基于发射光谱法开展了气体压强对纳秒激光诱导空气等离子体特性影响的研究,探讨了气体压强对空气等离子体发射光谱强度、电子温度和电子密度的影响.实验结果表明,在10-100 kPa空气压强条件下,空气等离子体发射光谱中的线状光谱和连续光谱依赖于气体压强变化,且原子谱线和离子谱线强度随气体压强的变化有明显差别.随着空气压强增大,激光击穿作用区域的空气密度增加,造成激光诱导击穿空气几率升高,从而等离子体辐射光谱强度增大.空气等离子体膨胀区域空气的约束作用,增加了等离子体内粒子间的碰撞几率以及能量交换几率,并且使离子-电子-原子的三体复合几率增加,因此造成原子谱线OⅠ777.2 nm与NⅠ821.6 nm谱线强度随着气体压强增大而增大,在80 kPa时谱线强度最高,随后谱线强度缓慢降低.而离子谱线N Ⅱ 500.5 nm谱线强度在40 kPa时达到最大值,气体压强大于40 kPa后,谱线强度随压强增加而逐渐降低.空气等离子体电子密度均随压强升高而增大,在80 kPa后增长速度变缓.等离子体电子温度在30 kPa时达到最大值,气体压强大于30 kPa后,等离子体电子温度逐渐降低.研究结果可为不同海拔高度的激光诱导空气等离子体特性的研究提供重要实验基础,为今后激光大气传输、大气组成分析提供重要的技术支持.     

Surface Modification of ZrO2–3Y2O3 with Highintensity Pulsed N2+ Ion Beams

Russian Physics Journal -     

湿度对水泥生料近红外光谱检测的影响及补偿方法

近红外光谱检测已被应用于水泥生料成分的快速检测,但现场环境中的湿度等因素会对光谱产生干扰,从而降低检测精度。为了提高检测精度,在实验分析湿度对水泥生料近红外光谱检测影响的基础上研究了补偿方法。在水泥厂选取了24份水泥生料样本,其中18份作为校正集,6份作为验证集;水泥生料中的有效成分为SiO2,Al2O3,Fe2O3和CaCO3,各成分含量的标准值由X射线荧光光谱分析测出。首先,将校正集的18份样本每份重复装样测5次光谱,用得到的90个光谱建立模型Ⅰ;再每份样品制作5个湿度梯度样本,其获得过程为,先将样本放置在电加热平台上,用玻璃棒将样本摊平,180℃下加热30 min,再将样本放置在散热片上进行降温,待样品恢复室温后取出进行第一次光谱扫描,得到1个光谱,将测量后的样本放入搅拌器,使用装有去离子水的喷雾器对其喷雾两次,然后搅拌30 s混合均匀,测量混合后的样本得到下一个光谱,重复该过程,得到具有湿度梯度的5个光谱。所有样本均采用烘干法进行湿度测量,样本湿度变化区间在0.6%~2%以内。对每个湿度梯度的样本测量1次,用得到的这90个光谱建立模型Ⅱ。然后,将验证集的6份样本每份制作5个湿度梯度,获取方式与校正集相同,对每个湿度梯度的样本测量1次,得到30个光谱。所有光谱均采用多元散射校正预处理,拟合波段选择4000~5000 cm^-1,建模方法采用偏最小二乘法。比较同一份样本的5个湿度梯度,可以看到在5200 cm^-1处光谱差异最大,在其他位置也有肉眼可见的明显差异,因此,湿度变化对全波段光谱有明显的影响。最后,将这30个光谱输入模型Ⅰ与模型Ⅱ进行验证,并对比模型Ⅰ与模型Ⅱ的预测均方根误差RMSEP。模型Ⅱ中SiO2,Al2O3,Fe2O3和CaCO3的预测均方根误差RMSEP比模型Ⅰ分别减小了25%,31.3%,33.3%和25%。实验结果表明,水泥生料样本湿度对近红外光谱模型的预测结果具有一定的影响,采用具有湿度梯度的样本进行建模可有效降低湿度对预测结果的影响。     

Regiocontrol in the oxidative Heck reaction of indole by ligand-enabled switch of the regioselectivity-determining step

Efficient control of regioselectivity is a key concern in transition-metal-catalyzed direct C–H functionalization reactions. Various strategies for regiocontrol have been established by tuning the selectivity of the C–H activation step as a common mode. Herein, we present our study on an alternative mode of regiocontrol, in which the selectivity of the C–H activation step is no longer a key concern. We found that, in a reaction where the C–H activation step exhibits a different regio-preference from the subsequent functionalization step, a ligand-enabled switch of the regioselectivity-determining step could provide efficient regiocontrol. This mode has been exemplified by the Pd(ii)-catalyzed aerobic oxidative Heck reaction of indoles, in which a ligand-controlled C3-/C2-selectivity was achieved for the first time by the development of sulfoxide-2-hydroxypyridine (SOHP) ligands.

Ligand-enabled switch of the regioselectivity-determining step allowed for efficient regiocontrol in the aerobic oxidative Heck reaction of indole.     

野外砾石统计方法的应用与对比

砾石对于研究构造活动和气候变化具有重要意义，而砾石粒径是其中的重要参数，如何准确地获取粒径数据则是砾石统计分析中的基础性工作。为了能更全面地了解和使用砾石统计方法，对地表砾石统计和地层砾石统计这2种方法从操作流程、抽样过程、样本容量、误差分析和适用条件等方面进行了分析和总结。地表砾石统计，主要有沃尔曼法和面积样本法，前者强调抽样的随机性，多适用于对粒径>2 mm砾石的统计，常用于研究砾质河床的砾石粒径顺流变化趋势；后者适用的粒径范围更广，可达细砂级沉积物，多用于探索河床砾-砂转换带和生物栖息环境划分等领域。地层砾石统计，大多使用体积样本法，强调砾石的成层性，可根据研究目的确定相应的网格筛，粒径范围也可达细砂级别，多用于沉积地层粒度对气候与构造的响应、河床监测和泥沙运移等方面。砾石统计方法的选择很大程度上取决于研究目的及野外工作条件，可根据实际情况灵活选择。     

高效液相色谱-荧光检测器法测定2-噁唑烷酮的含量

建立一种利用高效液相色谱结合荧光检测器准确测定2-噁唑烷酮含量的方法。样品中的2-噁唑烷酮和占吨氢醇在60℃的条件下衍生70 min后,直接进样分析。采用月旭XB-C18色谱柱,流动相为0.02 mol/L乙酸钠水溶液和乙腈,检测器波长为λex=213 nm,λem=308 nm,流速1.0 mL/min,柱温35℃的条件下。2-噁唑烷酮浓度在0.5~50.0mg/mL时,线性关系良好(R2=0.9995),检测限和定量限分别为0.005 mg/L、0.016 mg/L。该方法准确、灵敏、快速,适用于2-噁唑烷酮含量的检测。     

Copper Causes Regiospecific Formation of C4F8‐Containing Six‐Membered Rings and their Defluorination/Aromatization to C4F4‐Containing Rings in Triphenylene/1,4‐C4F8I2 Reactions

The presence of Cu in reactions of triphenylene (TRPH) and 1,4‐C₄F₈I₂ at 360 °C led to regiospecific substitution of TRPH ortho C(β) atoms to form C₄F₈‐containing rings, completely suppressing substitution on C(α) atoms. In addition, Cu caused selective reductive‐defluorination/aromatization (RD/A) to form C₄F₄‐containing aromatic rings. Without Cu, the reactions of TRPH and 1,4‐C₄F₈I₂ were not regiospecific and no RD/A was observed. These results, supported by DFT calculations, are the first examples of Cu‐promoted 1) regiospecific perfluoroannulation, 2) preparative C?F activation, and 3) RD/A. HPLC‐purified products were characterized by X‐ray diffraction, low‐temperature PES, and ¹H/¹⁹F NMR.     

Vitamin K1 distribution following intravenous vitamin K1–fat emulsion administration in rats

This study investigated vitamin K₁ (VK₁) distribution following intravenous vitamin K₁–fat emulsion (VK₁–FE) administration and compared it with that after VK₁ injection. Rats were intravenously injected with VK₁–FE or VK₁. The organ and tissue VK₁ concentrations were determined using high‐performance liquid chromatography method at 0.5, 2 and 4 h to determine distribution, equilibrium and elimination phases, respectively. In the VK₁–FE group, the plasma, heart and spleen VK₁ concentrations decreased over time. However, other organs like liver, lung, kidney, muscle and testis, reached peak VK₁ concentrations at 2 h. In the VK₁ injection group, the liver VK₁ concentrations were significantly higher than those in other organs at the three time points. However, VK₁ concentrations in the other organs peaked at 2 h. In addition, in VK₁–FE group, the heart, spleen and lung VK₁ concentrations were significantly higher than those in the VK₁ injection group at the three time points, and the liver VK₁ concentration was significantly higher than that in the VK₁ injection group at 4 h. The VK₁ amount was greatest in the liver compared with the other organs. Thus, the liver is the primary organ for VK₁ distribution. The distribution of VK₁ is more rapid when injected as VK₁–FE than as VK₁. Copyright © 2015 John Wiley & Sons, Ltd.